User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 275 System Manual
3.3.11.14.7 Configuring the Parameters of a VPWS-Mapped Service Group
After enabling the service group configuration mode for a VPWS-Mapped service
group, you can configure the following parameters for the service group:
Accounting parameters (see Section 3.3.11.14.7.1)
{acct
{none|time}}
The Accounting mode for the
service interface:
none: No accounting support.
time: The ASN-GW send
RADIUS Accounting
Start/Stop Requests. The
ASN-GW shall also send
Interim Accounting requests
to AAA server using RADIUS
Accounting Interim messages
on a preconfigured or
negotiated interval. AAA
server can send negotiated
time interval in
Access-Accept message. If
ASN GW defined value (see
acctInterimTmr below) is zero
and there is no
Acct-Interim-Interval in
Access Accept, interim
updates should be
deactivated.
Optional time
 none
 time
[acctInterim
Tmr
<integer(0|5
-1600)>]
Applicable only if acct (see
above) mode is set to time.
The default interval in
minutes for Accounting
Interim reports to be used if
Acct-Interim-Interval is not
received from the AAA
server.
Value “0” means interim
reports are deactivated
unless Acct-Interim-Interval is
sent by the AAA server in
Access Accept messages.
Optional 5
 0
 5-1600
Command
Modes
VPWS-QinQ Service group configuration mode