User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 274 System Manual
3.3.11.14.6 Configuring the Parameters of a VPWS-QinQ Service Group
After enabling the service group configuration mode for a VPWS-QinQ service
group, run the following command to configure the accounting parameters for the
service group:
npu(config-srvcgrp-VPWS)# config {acct {none|time} | acctInterimTmr
<integer(0|5-1600)>}
[acctInterim
Tmr
<integer(0|5
-1600)>]
Applicable only if acct (see
above) mode is set to time.
The default interval in
minutes for Accounting
Interim reports to be used if
Acct-Interim-Interval is not
received from the AAA
server.
Value “0” means interim
reports are deactivated
unless Acct-Interim-Interval is
sent by the AAA server in
Access Accept messages.
Optional 5
 0
 5-1600
Command
Modes
VPWS-Transparent Service group configuration mode
NOTE
You can display configuration information for the service group. For details, refer to
Section 3.3.11.15.2.
Command
Syntax
npu(config-srvcgrp)# config {acct {none|time} | acctInterimTmr
<integer(0|5-1600)>}
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values