User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 272 System Manual
3.3.11.14.4.4.4Terminating the DHCP Relay Configuration Mode
Run the following command to terminate the DHCP relay configuration mode for
this service group:
npu(config-srvcgrp-dhcprelay)# exit
3.3.11.14.5 Configuring the Parameters of a VPWS-Transparent Service Group
After enabling the service group configuration mode for a VPWS-Transparent
service group, run the following command to configure the accounting parameters
for the service group:
npu(config-srvcgrp-VPWS)# config {acct {none|time} | acctInterimTmr
<integer(0|5-1600)>}
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
no
[Subopt1value]
[Subopt2value]
[Subopt6value]
[Subopt7value]
Indicates the removal status
of DHCP Option 82
suboptions.
If no suboption is specified,
the values of all suboptions
will be removed.
Optional N/A N/A
Command
Mode
Service group-DHCP relay-Option 82 configuration mode
Command
Syntax
npu(config-srvcgrp-dhcprelay)# exit
Privilege
Level
10
Command
Modes
Service group-DHCP relay configuration mode
NOTE
You can display configuration information for the service group. For details, refer to
Section 3.3.11.15.2.