User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 269 System Manual
IMPORTANT

For DhcpRlOpt82SubOpt1BinFrstrng value, enter hex string without spaces.
 If Opt82Unicast is enabled then DHCP relay agent appends option 82 to all DHCP messages
(unicast and broadcast).
 If Opt82Unicast is disabled (default) then DHCP relay agent appends option 82 only to
broadcast DHCP request messages.
Command
Syntax
npu(config-srvcgrp-dhcprelay-Opt82)# config ([Subopt1value
{Default|MSID|BSID|NASID|NASIP|Full-NAI|Domain|AsciiFrStrng
<string(32)>|BinFrStrng <string(32)>}] [Subopt2value
{Default|MSID|BSID|NASID|NASIP|Full-NAI|Domain|AsciiFrStrng
<string(32)>|BinFrStrng <string(32)>}] [Subopt6value
{Default|MSID|BSID|NASID|NASIP|Full-NAI|Domain|AsciiFrStrng
<string(32)>|BinFrStrng <string(32)>}] [{Subopt7value [service-type]
[vendor-specific] [session-timeout]}] [{EnableUnicast|DisableUnicast}])
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible Values
[Subopt1value
{Default|MSID
|BSID|NASID|
NASIP|Full-NA
I|Domain|Asci
iFrStrng
<string(32)>|Bi
nFrStrng
<string(32)>}]
Configures the suboption 1
(Agent Circuit ID) of DHCP
option 82.
For
AsciiFrStrng (string
enter up to 32
characters,
For BinFrStrng (string
enter a string of up to
32 hexadecimal digits
(no spaces).
Optional Not Set
 Default
 MSID
 BSID
 NASID
 NASIP
 Full-NAI
 Domain
 AsciiFrStrng
(string32)
 BinFrStrng
(string32)