User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 266 System Manual
3.3.11.14.4.3.2Restoring the Default Configuration Parameters for the DHCP Proxy
Run the following command to restore the default values of one or several DHCP
proxy parameters. This command can also be used to delete the configured DNS
server address (if specified).
npu(config-srvcgrp-dhcpproxy)# no [offerreuse-holdtime]
[lease-interval] [dnssrvr-addr][renew-interval] [rebind-interval]
[dnssrvr-addr2]
Specify one or several parameters to restore the specified parameters to their
default values. Do not specify any parameter to restore all of these parameters to
their default values.
[Sname
<string(64)>]
Configures the proxy host
name. This parameter is
sent in dhcp-offer /
dhcp-ack messages and
may be used by certain
CPEs.
Optional empty
string
String (up to 64
characters)
[File
<string(128)>]
Configures the boot file
name. This parameter is
sent in dhcp-offer /
dhcp-ack messages and
may be used by certain
CPEs.
Optional empty
string
String (up to
128 characters)
[dnssrvr-addr2
<string>]
IP Address of the second
DNS Server to be
provisioned to MS from
this Group.
In the Proxy mode, this
value is used if appropriate
parameter is not received
in RADIUS
Access-Accept.
Optional 0.0.0.0
(none)
Valid IP
address
Command
Modes
Service group-DHCP proxy configuration mode
NOTE
Refer Section 3.3.11.14.4.3.1 for a description and default values of these parameters.