User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration

4Motion 263 System Manual

3.3.11.14.4.3 Configuring the DHCP Proxy

After enabling the service group operation mode for the DHCP proxy, you can

execute the following tasks:

 “Specifying DHCP Proxy Configuration Parameters” on page 263

 “Restoring the Default Configuration Parameters for the DHCP Proxy” on

page 266

 “Terminating the DHCP Proxy Configuration Mode” on page 267

3.3.11.14.4.3.1Specifying DHCP Proxy Configuration Parameters

Run the following command to configure the DHCP proxy:

npu(config-srvcgrp-dhcpproxy)# config ([offerreuse-holdtime

<integer>] [lease-interval <integer>] [dnssrvr-addr <string>]

[pool-subnet <string>] [dflt-gwaddr <string>] [renew-interval

<integer>] [rebind-interval <integer>] [opt60 <string(30)>] [opt43

{[Name <string(64)>] [Value <string(64)>]}] [Sname <string(64)>]

[File <string(128)>]) [dnssrvr-addr2 <string>]

Command

Modes

Service group-DHCP server configuration mode

IMPORTANT

An error may occur if you provide an invalid value for any of these parameters. Refer the syntax

description for more information about the appropriate values and format for configuring these

parameters.

Command

Syntax

npu(config-srvcgrp-dhcpproxy)# config ([offerreuse-holdtime

<integer>] [lease-interval <integer>] [dnssrvr-addr <string>]

[pool-subnet <string>] [dflt-gwaddr <string>] [renew-interval

<integer>] [rebind-interval <integer>] [opt60 <string(30)>] [opt43

{[Name <string(64)>] [Value <string(64)>]}] [Sname <string(64)>]

[File <string(128)>] [dnssrvr-addr2 <string>])

Privilege

Level