User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 260 System Manual
3.3.11.14.4.2.2Restoring Configuration Parameters for the DHCP Server
Run the following command to restore the default values of one or several DHCP
server parameters. This command can be used to delete the DNS server address
configuration (if specified).
npu(config-srvcgrp-dhcpserver)# no [lease-interval]
[renew-interval] [rebind-interval] [dnssrvr-addr]
[offerreuse-holdtime] [dnssrvr-addr2]
Specify one or several parameters to restore the specified parameters to their
default values. Do not specify any parameter to restore all of these parameters to
their default values.
3.3.11.14.4.2.3Configuring Exclude IP Addresses for the DHCP Server
Run the following command to configure exclude IP addresses for the DHCP
server:
npu(config-srvcgrp-dhcpserver)# exclude-addr <no. of Addrs (1-9)>
<ipv4addr> [<ipv4addr>] ….
In each command you may add up to 9 IP addresses to be excluded. The total
number of excluded IP addresses is up to a maximum of 16384.
NOTE
Refer to Section 3.3.11.14.4.2.1 for a description and default values of these parameters.
Command
Syntax
npu(config-srvcgrp-dhcpserver)# no
[lease-interval] [renew-interval]
[rebind-interval] [dnssrvr-addr] [offerreuse-holdtime]
[dnssrvr-addr2]
Privilege
Level
10
Command
Modes
Service group-DHCP server configuration mode
IMPORTANT
An error may occur if you provide an invalid IP address. Refer the syntax description for more
information about the appropriate values and format for configuring this parameters.