User's Manual

Document History
4Motion xxiv System Manual
Commissioning
Section 2.1
No need to configure ACL August 2008
Configuring Airftame Parameters
Section 3.8.16.2
Removed sections related to Cyclic Delay
Parameters, Linear Delay Parameters,
Mapping Parameters and Receive
Parameters. In General Parameters,
auto-diversity and auto-rx-enable were
removed.
Added notes regarding parameters that are
not relevant (ignored) in Uplink Feedback
Zone Parameters, Downlink Data Zone
Parameters, Uplink Data Zone Parameters,
MIMO Parameters.
August 2008
Restoring Default Values for Airframe
Parameters
Section 3.8.16.3
Removed sections related to Cyclic Delay
Parameters, Linear Delay Parameters,
Mapping Parameters, Receive Parameters
and Uplink Data Zone Parameters. In General
Parameters, auto-diversity and auto-rx-enable
were removed. Added a note that the
command for restoring the default values for
Uplink Data Zone parameters is not
applicable for the current release.
Added notes regarding parameters that are
not relevant (ignored) in MIMO Parameters.
August 2008
Displaying Configuration Information
for Airftame Parameters
Section 3.8.16.5
Removed sections related to Cyclic Delay
Parameters, Linear Delay Parameters,
Mapping Parameters and Receive
Parameters.
August 2008
Managing BS Feedback Allocation
Parameters
Section 3.8.7
Added a note related to max-cqi parameter
that cannot be modified.
August 2008
Configuring Power Control Target
Noise and Interference Level
Parameters
Section 3.8.6.2.1
Added a note related to cqi-ack-ranging
parameter that cannot be modified.
August 2008
Restoring the Default Values of
Power Control Target Noise and
Interference Level Parameters
Section 3.8.6.3.1
Added a note related to cqi-ack-ranging
parameter that cannot be restored to default
value.
August 2008
Topic Description Date Issued