User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 110 System Manual
npu(config-if)# mtu <frame-size(1518-9000)>
3.3.2.1.3 Managing VLAN Translation
4Motion supports translation of the VLAN ID for packets received and transmitted
on the DATA port to a configured VLAN ID. Before starting VLAN translation, first
enable VLAN translation, and then create one or more VLAN translation entries.
This section describes the commands for:
 “Enabling/Disabling VLAN Translation” on page 111
 “Creating a VLAN Translation Entry” on page 111
 “Deleting a VLAN Translation Entry” on page 113
Command
Syntax
npu(config-if)# mtu <frame-size(1518-9000)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<frame-size(15
18-9000)>
Indicates the MTU (in bytes)
to be configured for the
physical interface.
For the DATA interface the
range is from 1518 to 9000.
For all other interfaces the
following values are
supported by the hardware:
1518, 1522, 1526, 1536,
1552, 1664, 2048, 9022.
mandatory For the
DATA
interface the
default is
1664.
For all other
physical
interfaces
the default is
1522.
1518-9000
for the
DATA
interface.
1518, 1522,
1526, 1536,
1552,
1664, 2048,
9022 for all
other
interfaces.
Command
Modes
Interface configuration mode