User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 100 System Manual
This section describes the commands for:
 “Configuring the IP Connectivity Mode” on page 100
 “Displaying the IP connectivity Mode” on page 101
3.3.1.1 Configuring the IP Connectivity Mode
To configure the IP connectivity mode, run the following command:
npu(config)# connectivity mode {inband | outband | unified}
In-band is the default connectivity mode. You can display the currently configured
connectivity mode. For details, refer Section 3.3.1.2.
Table 3-9: Ethernet and IP Domain VLAN-to-Connectivity Mode Configuration
Connectivity
Mode
Bearer IP Domain External-Management
IP Domain
Local-management IP
Domain
Out-of-band
 DATA port
 Bearer VLAN
 MGMT port
 External-management
VLAN
 CSCD port
 Local-management
VLAN
In-band
 DATA port
 Bearer VLAN
 DATA port
 External-management
VLAN
 CSCD and MGMT
ports
 Local-management
VLAN
Unified
 DATA port
 Bearer VLAN
 DATA port
 Bearer VLAN
 CSCD and MGMT
ports
 Local-management
VLAN
IMPORTANT
You must save the configuration (run the command npu# write) for a change in connectivity mode
to take effect after next reset.
Command
Syntax
npu(config)# connectivity mode {inband | outband | unified}
Privilege
Level
10