User's Manual

Chapter 3 - Operation and Administration Using the CLI Using the Command Line Interface for Management
4Motion 83 System Manual
npu(config)# no enable password [Level <0-10>]
3.1.6.3 Enabling/Disabling Higher Privilege Levels
You can execute commands that require higher privilege levels. If the admin user
has configured a password for that level, you can use that password to enable
higher privilege levels.
For example, if your privilege level is 1, you can provide the password configured
for privilege level 10 to execute all commands that require privilege level 10.
This section describes the commands for:
 “Enabling a Higher Privilege Level” on page 84
 “Returning to the Default Privilege Level” on page 85
IMPORTANT
An error may occur if:
 The privilege level that you have specified is not within the range, 0-10.
 You are trying to delete a password for a privilege level that is higher than your default privilege
level.
Command
Syntax
npu(config)# no enable password [Level <0-10>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[Level <0-10>] Indicates the privilege level
for which a password is to be
disabled.
Optional 10 0-10
Command
Syntax
Global configuration mode