User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 240 System Manual
3.3.11.13.1.1 Enabling the AAA Client Configuration Mode
To configure the AAA client parameters, first enable the AAA client configuration
mode. Run the following command to enable the AAA client configuration mode.
npu(config)# aaa-client <client-alias>
The system is supplied with a pre-configured AAA client with the following
properties that cannot be modified:
client-alias: default
src-intf: Bearer
After enabling the AAA client configuration mode you can execute any of the
following tasks:
 Configure the AAA client parameters (refer to Section 3.3.11.13.1.2)
 Terminate the AAA client configuration mode and return to the global
configuration mode (refer to Section 3.3.11.13.1.3).
Command
Syntax
npu(config)# aaa-client <client-alias>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<client-alias> Denotes the client-alias of the
AAA client for which the
configuration mode is to be
enabled.
In the current release a single
AAA client is supported, with
client-alias “default”.
Mandatory N/A default
Command
Modes
Global configuration mode