User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 228 System Manual
3.3.11.12 Managing Service Interfaces
A Service Interface defines the parameters of the interface used by the ASN-GW on
the network side for services specified in the applicable Service Group.
The following types of Service Interface are available:
 IP-IP: The Service Interface defines the parameters on the ASN-GW side of a
point-to-point tunnel to be used for the applicable traffic.
 VLAN: The Service Interface defines the VLAN ID to be added/removed by the
ASN-GW to/from the applicable traffic.
 QinQ: Applicable only for special applications requiring local support of
unauthenticated mode. The QinQ Service Interface is applicable only for
supporting VLAN CS Service Flows associated with a QinQ Service Group.
Up to 10 Service Interfaces may be defined.
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[<qos-alias>] Denotes the QoS alias of the
bearer QoS marking rule that
you want to display.
Specify a value for this
parameter if you want to
display a specific bearer QoS
marking rule. Do not specify a
value for this parameter if you
want to display all bearer QoS
marking rules.
Optional N/A String
Display
Format
Bearer QoS Configuration :
qos-alias intf-type srvc-type trfc-priority media-type inner-dscp
outer-dscp vlan-priority status
voip <value> <value> <value> <value> <value> <value> enabled
Command
Modes
Global command mode