User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 220 System Manual
1 Enable the bearer plane QoS marking rules configuration mode (refer to
Section 3.3.11.11.1)
2 You can now execute any of the following tasks:
» Configure the output parameters for bearer plane QoS marking rules (refer
to Section 3.3.11.11.2)
» Restore the default parameters for bearer plane QoS marking rules (refer to
Section 3.3.11.11.3)
3 Terminate the bearer plane QoS marking rules configuration mode (refer to
Section 3.3.11.11.4)
In addition, you can, at any time, display configuration information (refer to
Section 3.3.11.11.6) or delete an existing bearer plane QoS marking rule (refer to
Section 3.3.11.11.5).
3.3.11.11.1 Enabling the Bearer Plane QoS Marking Rule Configuration
Mode\Creating a Bearer Plane QoS Marking Rule
To configure the parameters for the bearer plane QoS marking rules, first enable
the bearer plane QoS marking rule configuration mode. Run the following
command to enable the bearer plane QoS marking rules configuration mode. You
can also use this command to create and enable the configuration mode for a new
bearer plane QoS marking rule.
npu(config)# bearerqos <qos-alias> [<intf-type((1<R3> - 0<R6>)|
255<ANY>)> <srvc-type(0<UGS> | 1<RTVR> | 2<NRTVR> | 3<BE> |
4<ERTVR> | 255<ANY>)> <trfc-priority((0-7)|255)> <media-type> ]
To configure one or more QoS bearer plane marking rules:
NOTE
You can display configuration information for the bearer plane QoS marking rules. For details, refer
to
Section 3.3.11.11.6.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.