User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 287 System Manual
If you use this command to create a new service flow, the configuration mode for
this service flow is automatically enabled, after which you can execute any of the
following tasks:
 Configure the parameters for this service flow (refer to Section 3.3.11.15.3.3.2)
 Restore the default parameters for this service flow (refer to
Section 3.3.11.15.3.3.3)
 Configure uplink/downlink classification rule names (refer to
Section 3.3.11.15.3.3.4)
After you have executed these tasks, you can terminate the service flow
configuration mode, and return to the service profile configuration mode (refer to
Section 3.3.11.15.3.3.6).
Command
Syntax
npu(config-srvcprfl)#flow [<flow-id (1-255)] [grp-alias <srvc-grp-alias>]
[
if-alias <string>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
flow [<flow-id
(1-255)]
Denotes the flow ID of the
service flow for which the
service flow configuration
mode is to be enabled. If you
are creating a new service
flow, specify the service flow
ID of the new service flow.
The configuration mode is
automatically enabled for the
new service flow.
Mandatory N/A 1-255