User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing AUs
4Motion 417 System Manual
3.5.2.2 Configuring the Control Parameter
The control parameters enables controlling the operation of the AU.
To configure the control parameter, run the following command:
npu(config-au-1)# control shutdown-operation {normalOperation | reset |
shutdown}
Command
Syntax
npu(config-au-1)# properties [required-type <au4x4Modem |au2x2> ]
[port-1-power {shutDown | noShutDown} ] [port-2-power {shutDown |
noShutDown} ] [port-3-power {shutDown | noShutDown} ]
[port-4-power {shutDown | noShutDown} ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[required-type
<au4x4Modem
|au2x2>
Defines the AU card
configuration required : 4-ports
or 2-ports.. 2-ports AU is
applicable only for Macro
Outdoor.
Optional au4x4Mo
dem
 au4x4Modem
 au2x2
[port-1-power
{shutDown |
noShutDown} ]
Controls power from AU card
port 1 to ODU
Optional No
Shutdown
 shutDown
 noShutDown
[port-2-power
{shutDown |
noShutDown} ]
Controls power from AU card
port 2 to ODU.
Optional No
Shutdown
 shutDown
 noShutDown
[port-3-power
{shutDown |
noShutDown |} ]
Controls power from AU card
port 3 to ODU. Not applicable
for a 2-ports AU..
Optional No
Shutdown
 shutDown
 noShutDown
[port-4-power
{shutDown |
noShutDown} ]
Controls power from AU card
port 4 to ODU. Not applicable
for a 2-ports AU.
Optional No
Shutdown
 shutDown
 noShutDown
Command
Modes
au configuration mode