User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 363 System Manual
For example, run the following command if you want to enable performance data
collection for the NPU DATA port:
npu(config)# pm-group enable npu BckhlPort
When you run this command, collection and storage of performance data is
enabled for the DATA port counters.
After you have enabled collection and storage of performance data is fetched every
quarter of an hour.
BsMobilityTable
Mobility
BsNetworkEntryTable
Network Entry
BsTrafficTable
Traffic
BsUtilizationTable
Utilization
BsIdleModeTable
Idle Mode
BsFastFeedbackCQIHandlingTable
Fast Feedback CQI Handling
BsAckNackChannelHandlingTable
Ack/Nack Channel Handling
BsEndTransactionUpdateTable
End Transaction Update
BsDlDataZoneFrameHistogramsTable
DL Frame Data Zone Histograms
BsTxR1NetTrafficTable
TxR1 Net Traffic
BsRxR1NetTrafficTable
RxR1 Net Traffic
BsTxR1TotalTrafficTable
TxR1 Total Traffic
BsRxR1TotalTrafficTable
RxR1 Total Traffic
BsDLHARQSbDropsTable
DL HARQ Sub-Bursts Drop
BsDLHARQTransmissionTable
DL HARQ Transmissions
BsGeneral
General
Bsallmsbasicmode
All MS Basic Modec
Bsspecificmsadvancedmode
Specific MS Advanced Mode
NOTE
When you enable collection of performance data collection, the data is stored in a file called,
prf_<SiteID>_yyyymmddhhmm.xml.gz in the path, /tftpboot/management/performance. It is
recommended that you periodically make a backup of these files on an external server.
Table 3-26: AU Counters Groups for which Performance Data can be Collected
Parameter Name Refers to...