User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 396 System Manual
In addition to the configurable parameters, the current number of satellites
acquired by the GPS receiver is also displayed.
3.3.15.3 Managing Power Feeders Configuration
The Power Feeder configuration enables specifying the AU port connected to each
Power Feeder port.
3.3.15.3.1 Configuring Power Feeders
To configure the AU ports connected to the ports of a specific Power Feeder, run
the following command:
npu(config)# config pfUnitNo <pfunit no (1-4)> pfPortNo <pfport no
(1-4)> AuSlotNo <AuslotNo (-1,1-4,7-9)> AuPortNo <AuPortNo
(-1,1-4)>
Display
Format
Max Satellites Before Sync Loss :
Min Satellites For Holdover Return :
Number of Satellites Acquired :
Command
Modes
Global command mode
IMPORTANT
An error can occur if the configured combination of AuPortNo and AuSlotNo already exists.
Command
Syntax
npu(config)# config pfUnitNo <pfunit no (1-4)> pfPortNo <pfport no (1-4)>
AuSlotNo <AuslotNo (-1,1-4,7-9)> AuPort <AuPortNo (-1,1-4)>
Privilege
Level
10
Syntax
Description
Parameter Description Prese
nce
Default
Value
Possible
Values
pfUnitNo
<pfunit no
(1-4)>
The Power Feeder unit
number.
Mandatory N/A 1-4