User's Manual

Chapter 3 - Operation and Administration Using the CLI Troubleshooting
4Motion 670 System Manual
3.11.1.2 Configuring Module-level Tracing
After configuring module-level tracing, you can specify whether brief or detailed
traces should be recorded for the following modules:
 System startup procedures
 NPU/AU upgrade procedures
 Fault management procedures
 System performance procedures
 Shelf Management procedures
 WiMAX signaling protocols
 User interface
 AU Management procedures
You can also disable tracing for a particular module. This section describes the
commands to be used for:
IMPORTANT
This command may not be successfully executed if an internal error occurs while processing the
result.
Command
Syntax
npu(config)# show trace destination
Privilege
Level
1
Display
Format
Tracefile(<file name>) : Enabled/Disabled
Console(<console>) : Enabled/Disabled
Command
Modes
Global command mode