User's Manual

Chapter 3 - Operation and Administration Using the CLI Monitoring Performance of Hardware and Software
4Motion 656 System Manual
3.10 Monitoring Performance of Hardware
and Software Components
This section describes the procedures for:
 “Monitoring Hardware Components” on page 656
 “Monitoring Software Components” on page 662
 “Displaying Statistics for Physical and IP Interfaces” on page 663
 “Displaying System Files” on page 664
3.10.1 Monitoring Hardware Components
You can use the CLI to monitor performance of the following hardware
components with respect to:
 “Displaying the Card Types Installed in Shelf Slots 1 - 9” on page 656
 “Displaying the Current Status of Shelf Components” on page 657
 “Displaying Utilization of CPU and Memory Resources for the NPU” on
page 659
 “Displaying Packets Discarded Via Rate Limiting” on page 660
3.10.1.1 Displaying the Card Types Installed in Shelf Slots 1 - 9
To view the types of cards that are currently installed in slots 1-9 of the shelf run
the following command:
npu# show shelf-view
Command
Syntax
npu# show shelf-view
Privilege
Level
1