User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 620 System Manual
3.8.23.4 Terminating the Ranging Configuration Mode
Run the following command to terminate the Ranging configuration mode:
npu(config-bs-66053-ranging)# exit
3.8.23.5 Displaying Configuration Information for Ranging
Parameters
To display configuration for the Ranging General parameters, run the following
command:
npu# show ranging-general bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display configuration for a particular BS. For
example, to display the Ranging General parameters of BS 66053, run the
following command:
npu# show ranging-general bs 66053
Privilege
Level
10
Command
Modes
bs ranging configuration mode
IMPORTANT
If you did not configure any of the BS General parameters, do not forget to execute the apply
command before terminating the CRanging configuration mode:
npu(config-bs-66053-ranging)# apply
Command
Syntax
npu(config-bs-66053-ranging)# exit
Privilege
Level
10
Command
Modes
bs ranging configuration mode