User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 614 System Manual
3.8.22 Managing ID-IP Mapping Parameters
After enabling the BS configuration mode, you can execute the following tasks:
 Configure one or more ID-IP Mapping entry (refer to Section 3.8.22.1).
 Delete one or more ID-IP Mapping entries (refer to Section 3.8.22.2).
You can display configuration information for the ID-IP Mapping of a selected or
all existing BSs (refer to Section 3.8.22.3).
3.8.22.1 Configuring ID-IP Mapping Entries
From the BS configuration mode, run the following command:
npu(config-bs-66053)# idip <(1 to 16777215 StepSize 1)> [nw-node-ip <ip
address>]
To configure ID-IP Mapping entries:
Command
Syntax
npu(config-bs-66053)# idip <(1 to 16777215 StepSize 1)> [nw-node-ip
<ip address> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The Next Hop (Network
Node) BS ID
Mandatory N/A 1 - 16777215
nw-node-ip <ip
address>
The Next Hop (Network
Node) BS IP Address
Mandatory N/A IP address
Command
Modes
bs configuration mode
IMPORTANT
When creating a new BS, at least one ID-IP Mapping entry must be configured.