User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 612 System Manual
3.8.21.5.3 Displaying Configuration Information for All Control Traffic QoS
Marking Rules Parameters
To display configuration for all Control Traffic QoS Marking Rules parameters,
run the following command:
npu# show ctrltrafficqos-all bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display configuration for a particular BS. For
example, to display all Control Traffic QoS Marking Rules parameters of BS
66053, run the following command:
Command
Syntax
npu# show ctrltrafficqos-intraasn bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display the Intra ASN Traffic
QoS Marking Rules
parameters of a specific BS.
Do not specify a value for this
parameter if you want to
display the Intra ASN Traffic
QoS Marking Rules
parameters of all BSs.
Optional N/A 1-16777215
Display
Format
(for each
existing BS
if requested
for all BSs)
BSIDLSB :<value>
IntraASNDSCP :<value>
IntraASN802.1pPriority :<value>
Command
Modes
Global command mode