User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 605 System Manual
3.8.21 Managing Control Traffic QoS Marking Rules
Control Traffic QoS Marking Rules are used to define the DSCP and VLAN Priority
(802.1p) value to be used for marking of internal management traffic
(management traffic to/from the AUs) and intra-ASN (R8/R6) management traffic.
1 Enable the Control Traffic QoS Marking Rules configuration mode (refer to
Section 3.8.21.1)
2 You can now execute any of the following tasks:
» Configure one or more of the Control Traffic QoS Marking Rules
parameters tables (refer to Section 3.8.21.2)
» Restore the default values of parameters in one or more of the Control
Traffic QoS Marking Rules parameters tables (refer to Section 3.8.21.3)
» Terminate the Control Traffic QoS Marking Rules configuration mode
(refer to Section 3.8.21.4)
In addition, you can, at any time, display configuration information for each of the
parameters tables (refer to Section 3.8.21.5).
3.8.21.1 Enabling the Control Traffic QoS Marking Rules
Configuration Mode
To configure the Control Traffic QoS Marking Rules parameters, first enable the
Control Traffic QoS Marking Rules configuration mode. Run the following
command to enable the Control Traffic QoS Marking Rules configuration mode.
npu(config-bs-66053)# ctrltrafficqos
The configuration mode for the Control Traffic QoS Marking Rules is enabled,
after which you can execute any of the following tasks:
 Configure one or more of the Control Traffic QoS Marking Rules parameters
tables (refer to Section 3.8.21.2)
 Restore the default values of parameters in one or more of the parameters
tables (refer to Section 3.8.21.3)
To configure the Control Traffic QoS Marking Rules: