User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 565 System Manual
3.8.16.2.6 Configuring Airframe Uplink Data Zone Parameters
To configure the Airframe Uplink Data Zone parameters, run the following
command:
npu(config-bs-66053-airframe)# uldatazone [permbase <(0 to 69 StepSize 1)>]
[startallocation <(0 to 209 StepSize 1)>] [subchannels-number <(1 to 35 StepSize
1)>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[subchannels <(1 to
30 StepSize 1)> ]
The number of subchannels
used in thedownlink data
zone.
In the current release the
value is set internally: If
bandwidth=7MHz or
10MHz, value is set to 30. If
bandwidth=5MHz, value is
set to 15. An attempt to set
a different value will be
ignored.
Mandatory
when
creating a
new BS.
N/A 1-30
[permbase <(0 to 31
StepSize 1)> ]
The permutation base used
in the downlink data zone
Mandatory
when
creating a
new BS.
N/A 0 - 31
Command
Modes
bs airframe configuration mode
NOTE
An attempt to configure the subchannels-number or startallocation parameters will be ignored. The
value of subchannels-number is set by internal logic according to the configured bandwidth. The
value of startallocation is hardcoded to 0.
IMPORTANT
When creating a new BS, the Airframe Structure Uplink Data Zone mandatory permbase parameter
must be configured.