User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 544 System Manual
3.8.13.7.3 Displaying Configuration Information for Neighbor BS Trigger Setup
Parameters
To display configuration for the Neighbor BS Trigger Setup parameters, run the
following command:
npu# show nbr-triggersetup bs [<(1 to 16777215 StepSize 1)> bs-id-lsb <(1 to
16777215 StepSize 1)>]
Specify the BS ID and the Neighbor BS ID (bs-id-lsb) if you want to display
configuration for a particular Neighbor BS in a particular BS. For example, to
bs-id-lsb <(1 to
16777215
StepSize 1)>
The Neighbour BS ID.
Specify a value for this
parameter if you want to
display the Required C/N
Level parameters of a specific
Neighbour BS in a specific
BS. Do not specify a value for
this parameter if you want to
display the Required C/N
Level parameters of all
Neighbour BSs in all BSs.
Optional N/A 1-16777215
Display
Format
(for each
existing
Neighbour
BS in each
of the
existing BSs
if requested
for all)
BSIDLSB :<value>
NeighborBSIDLSB :<value>
RequiredCNRforACK :<value>
RequiredCNRforCQI :<value>
RequiredCNRforCDMA :<value>
RequiredCNRforQPSK1/2 :<value>
RequiredCNRforQPSK3/4 :<value>
RequiredCNRfor16QAM1/2 :<value>
RequiredCNRfor16QAM3/4 :<value>
RequiredCNRfor64QAM1/2 :<value>
RequiredCNRfor64QAM2/3 :<value>
RequiredCNRfor64QAM3/4 :<value>
RequiredCNRfor64QAM5/6 :<value>
Command
Modes
Global command mode