User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 539 System Manual
3.8.13.4.2 Deleting Neighbor BS Specific BS Triggers
To delete an entry from the neighbor BS specific BS triggers table run the
following command:
npu(config-bs-66053-nbr-68000)# no <specific-trigger-name>
3.8.13.5 Terminating the Neighbor BS Configuration Mode
Run the following command to terminate the Neighbor BS configuration mode:
npu(config-bs-66053-nbr-68000)# exit
NOTE
Refer to Table 3-32 for a description and possible values of the triggers.
Command
Syntax
npu(config-bs-66053-nbr-68000)# no <specific-trigger-name>
Privilege
Level
10
Command
Modes
bs neighbour bs configuration mode
IMPORTANT
Do not forget to execute the apply command before terminating the Neighbour BS configuration
mode:
npu(config-bs-66053-nbr-68000)# apply
Command
Syntax
npu(config-bs-66053-nbr-68000)# exit
Privilege
Level
10
Command
Modes
bs neighbour bs configuration mode