User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 536 System Manual
 Trigger Setup (refer to Section 3.8.13.3.3)
3.8.13.3.1 Restoring the Default Values of Neighbor BS General Parameters
To restore one or all of the Neighbor BS non-mandatory General parameters to
their default values, run the following command:
npu(config-bs-66053-nbr-68000)# no general [syncind] [srvcsupport]
[eirx-pir-max] [paging-grp-id ] [nbr-strt-rng-codes ]
You can restore only some parameters to the default values by specifying only
those parameters. For example, to restore only the syncind to the default value,
run the following command:
npu(config-bs-66053-nbr-68000)# no general syncind
The parameter will be restored to its default value, while the other parameters will
remain unchanged.
To restore all non-mandatory parameters to their default value, run the following
command:
npu(config-bs-66053-nbr-68000)# no general
3.8.13.3.2 Restoring the Default Values of Neighbor BS Required C/N Level
Parameters
To restore some or all of the Neighbor BS Required C/N Levels parameters to their
default values, run the following command:
npu(config-bs-66053-bs-68000)# no requiredcnr [ack] [cqi] [cdma] [qpsk-1by2]
[qpsk-3by4] [qam16-1by2] [qam16-3by4] [qam64-1by2] [qam64-2by3]
[qam64-3by4] [qam64-5by6]
NOTE
Refer to Section 3.8.13.2.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-nbr-68000)# no general [syncind ]
[srvcsupport][eirx-pir-max ][paging-grp-id ][nbr-strt-rng-codes]
Privilege
Level
10
Command
Modes
bs neighbour bs configuration mode