User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration

4Motion 375 System Manual

3.3.14.2.2 Deleting an Entry for the Trap Manager

To delete a Trap Manager, run the following command:

npu(config)# no trap-mgr ip-source <ip_addr>

[Port

<(0-65535)>]

Indicates the port number on

which the Trap Manager will

listen for messages from the

Agent.

Optional 162 0-65535

[TrapCommunity

<string>]

Indicates the name of the

community of the Trap

Manager.

Optional public String (up to 10

characters and

case-sensitive)

[EnableFlag<in

teger(1 for

enable, 2 for

disable)>]

Indicates whether traps

sending to the Trap Manager

is to be enabled. or disabled

Optional 1

 1: Indicates

enable

 2 Indicates

disable

Command

Modes

Global configuration mode

IMPORTANT

A route to forward traps to a configured Trap Manager IP address must exist. For details refer to

“Configuring Static Routes” on page 167. .

IMPORTANT

An error may occur if the IP address you have specifed does not exist.

Command

Syntax

npu(config)# no trap-mgr ip-source <ip_addr>

Privilege

Level