User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 522 System Manual
You can restore only one parameter to the default values by specifying only that
parameters. For example, to restore only the fastrangingalloc parameter to the
default value, run the following command:
npu(config-bs-66053)# no honegotiation-tbs fastrangingalloc
This parameter will be restored to its default value, while the other parameter will
remain unchanged.
To restore all Handover Negotiation at TBS parameters to their default value, run
the following command:
npu(config-bs-66053)# no honegotiation-tbs
3.8.12.3 Displaying Configuration Information for Handover
Negotiation at TBS Parameters
To display configuration information for Handover Negotiation at TBS parameters,
run the following command:
npu# show honegotiation-tbs bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display configuration for a particular BS. For
example, to display the Handover Negotiation at TBS parameters of BS 66053, run
the following command:
npu# show honegotiation-tbs bs 66053
Do not specify this parameter if you want to view configuration information for all
existing BSs. To display information for all BSs, run the following command:
npu# show honegotiation-tbs bs
NOTE
Refer to Section 3.8.12.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053)# no honegotiation-stbs [defaultactiontime ]
[fastrangingalloc ]
Privilege
Level
10
Command
Modes
bs configuration mode