User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs

4Motion 509 System Manual

3.8.8.2 Restoring the Default Values of Neighbor Advertisement

Parameter

Since there is only one Neighbor Advertisement parameter, run any of the

following commands to restore it to the default value:

npu(config-bs-66053)# no nbradvertise

npu(config-bs-66053)# no nbradvertise triggersetup

3.8.8.3 Displaying Configuration Information for Neighbor

Advertisement Parameters

To display configuration information for the Neighbor Advertisement parameter,

run the following command:

npu# show nbradvertise bs [<(1 to 16777215 StepSize 1)

Specify the BS ID if you want to display configuration for a particular BS. For

example, to display the Neighbor Advertisement parameters of BS 66053, run the

following command:

npu# show nbradvertise bs 66053

Do not specify this parameter if you want to view configuration information for all

existing BSs. To display information for all BSs, run the following command:

npu# show nbradvertise bs

NOTE

Refer to Section 3.8.8.1 for a description and default values of these parameters.

Command

Syntax

npu(config-bs-66053)# no nbradvertise [triggersetup]

Privilege

Level

Command

Modes

bs configuration mode