User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 491 System Manual
3.8.6 Managing Power Control Levels
1 Enable the Power Control configuration mode (refer to Section 3.8.6.1)
2 You can now execute any of the following tasks:
» Configure one or more of the Power Control parameters tables (refer to
Section 3.8.6.2)
» Restore the default values of parameters in one or more of the Power
Control parameters tables (refer to Section 3.8.6.3)
» Terminate the Power Control configuration mode (refer to Section 3.8.6.4)
In addition, you can, at any time, display configuration information for each of the
parameters tables (refer to Section 3.8.6.5).
3.8.6.1 Enabling the Power Control Configuration Mode
To configure the Power Control parameters, first enable the Power Control
configuration mode. Run the following command to enable the Power Control
configuration mode.
npu(config-bs-66053)# pwrctrl
The Power Control configuration mode is enabled, after which you can execute
any of the following tasks:
 Configure one or more of the Power Control parameters tables (refer to
Section 3.8.6.2)
rule-index <(1 to 255
StepSize 1)>]
The Service Mapping Rule
index. To be used only if you
want to display all parameters
of a specific Service Mapping
Rule.
Optional N/A 1-255
Command
Modes
Global command mode
To configure the Power Control Levels: