User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 485 System Manual
3.8.5.6.2 Displaying Configuration Information for Service Mapping Rule Order
Parameters
To display configuration for the order parameters of a specific or all Service
Mapping Rules, run the following command:
npu# show srvcmaprule-order bs [<(1 to 16777215 StepSize 1)> rule-index <(1 to
255 StepSize 1)>]
Specify the BS ID and Service Mapping Rule index if you want to display
configuration for a particular Service Mapping Rule. For example, to display the
order parameters of Service Mapping Rule 1 in BS 66053, run the following
command:
npu# show srvcmaprule-order bs 66053 rule-index 1
Do not specify these parameters if you want to view configuration information for
all existing Service Mapping Rules. To display information for all Service Mapping
Rules, run the following command:
npu# show srvcmaprule-order bs
rule-index <(1 to
255 StepSize 1)> ]
The Service Mapping Rule
index. To be used only if you
want to display the general
parameters of a specific
Service Mapping Rule.
Optional N/A 1-255
Display
Format
(for each
existing
Service
Mapping
Rule if
requested
for all
Service
Mapping
Rules)
BSIDLSB :<value>
MappingRuleIndex :<value>
ServiceName :<value>
Command
Modes
Global command mode