User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 475 System Manual
3.8.5.2.2 Configuring the Order Parameters
The Order Parameters table enables configuring the look-up-order parameter that
defines the order in which conceptual rows of the table are checked to find a
match.
To configure the Order parameters, run the following command:
npu(config-bs-66053-srvcmaprule-1)# order look-up-order <(1 to 255
StepSize 1)>
[srvc <string (32)> ] The service type to which the
connection will be mapped.
Must be the same as the
name (type) configured for
the relevant service (refer to
Section 3.8.4).
All service with the same R1
data delivery type (see
Section 3.8.5.2.3) must
be mapped to services with
the same HARQ properties
(max-dl-rtx, max-ul-rtx,
max-subburst, trgt-err-rate).
For details see
Section 3.8.4.2.
Mandatory A string of 1
to 32 printable
characters.
Command
Modes
bs service mapping rule configuration mode
IMPORTANT
When creating a new Service Mapping Rule, the mandaory order parameter must be configured.
Command
Syntax
npu(config-bs-66053-srvcmaprule-1)# order [look-up-order <(1 to
255 StepSize 1)> ]
Privilege
Level
10