User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 474 System Manual
 General (refer to Section 3.8.5.2.1)
 Order (refer to Section 3.8.5.2.2)
 R1 Profile (refer to Section 3.8.5.2.3)
 R6 Profile (refer to Section 3.8.5.2.4)
3.8.5.2.1 Configuring General Service Mapping Rule Parameters
The General Service Mapping Parameters table enables associating the Service
Mapping Rule to a specific Service.
To configure the General Service Mapping Rule parameters, run the following
command:
npu(config-bs-66053-srvcmaprule-1)# general srvc <string (32)>
IMPORTANT
After completing the Service Mapping Rule configuration,do not forget to execute the apply
command before exiting the BS Service Mapping Rule configuration mode:
npu(config-bs-66053-srvcmaprule-1)# apply
IMPORTANT
When creating a new Service Mapping Rule, the mandatory srvc parameters must be configured.
Command
Syntax
npu(config-bs-66053-srvcmaprule-1)# general srvc <string (32)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values