User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 473 System Manual
 Restore the default values of parameters in one or more of the parameters
tables of the Service Mapping Rule (refer to Section 3.8.5.3)
After executing the above tasks, you can terminate the Service Mapping Rule
configuration mode (refer to Section 3.8.5.4) and return to the BS configuration
mode.
Note that for properly completing the configuration of a Service Mapping Rule the
apply command must be executed prior to exiting the BS Service Mapping Rule
configuration mode.
For example, to define Service Mapping Rule 1 for BS 66053, run the following
command:
npu(config-bs-66053)# srvcmaprule 1
3.8.5.2 Configuring Service Mapping Rule Parameters
After enabling the Service Mapping Rule configuration mode you can configure the
following parameters tables:
Command
Syntax
npu(config-bs-66053)# srvcmaprule <(1 to 255 StepSize 1)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
srvcmaprule
<(1 to 255
StepSize 1)>
The Service Mapping Rule
index
Mandatory 1 - 255
Command
Modes
BS configuration mode
NOTE
The following examples are for BS Service Mapping Rule configuration mode for bs-66053, service
mapping rule (srvcmaprule)-1.