User's Manual
Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 472 System Manual
2 You can now execute any of the following tasks:
» Configure one or more of the parameters tables of the Service Mapping
Rule (refer to Section 3.8.5.2)
» Restore the default values of parameters in one or more of the parameters
tables of the Service Mapping Rule (refer to Section 3.8.5.3)
» Terminate the Service Mapping Rule configuration mode (refer to
Section 3.8.5.4)
In addition, you can, at any time, display configuration information for each of the
parameters tables of the Service Mapping Rule (refer to Section 3.8.5.6) or delete
an existing Service Mapping Rule (refer to Section 3.8.5.5).
3.8.5.1 Enabling the Service Mapping Rule Configuration
Mode\Creating a Service Mapping Rule
To configure the parameters of a Service Mapping Rule, first enable the BS Service
Mapping Rule configuration mode for the specific Service Mapping Rule. Run the
following command to enable the BS Service Mapping Rule configuration mode.
You can also use this command to create a new Service Mapping Rule.
Note that for a new Service Mapping Rule this command only defines the Service
Mapping Rule index, and that the Service Mapping Rule is not fully created until
completing configuration of all mandatory parameters and executing the apply
command (must be executed before exiting the BS Service Mapping Rule
configuration mode). Also when updating an existing Service Mapping Rule, the
apply command must be executing prior to termination the Service Mapping Rule
configuration mode.
npu(config-bs-66053)# srvcmaprule <(1 to 255 StepSize 1)
For example, to define a new Service Mapping Rule index 1, or to enable the
configuration mode for Service Mapping Rule 1, run the following command:
npu(config-bs-66053)# srvcmaprule 1
If you use this command to create a new Service Mapping Rule, the configuration
mode for this Service Mapping Rule is automatically enabled, after which you can
execute any of the following tasks:
Configure one or more of the parameters tables of the Service Mapping Rule
(refer to Section 3.8.5.2)