User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
Chapter 4 - Operation and Administration
aborted before completion. The following additional counters are displayed to
indicate the reason for and the nature of the event:
f dropped frames, which are unsuccessfully
retransmitted without being acknowledged until the maximum permitted
derrun: The number of times that transmission of a frame was aborted
for transmission exceeds the
available transmission capability.
er than those represented by the other
of frames received
from
rames
r of frames that were not received properly.
or the
CRC: The number of frames received from the wireless medium containing
CRC errors.
ve
rate exceeded the processing capability or the capacity of the Ethernet
that were not received properly due to a
ames: The total number of concatenated
frames received from the wireless medium, including duplicate frames. There
catenated frames that include one frame
Dropped: The number o
number of retransmissions.
Un
because the rate of submitting frames
Others: The number of frames whose transmission was not completed or
delayed due to a problem oth
counters.
Total received frames from wireless: The total number
from the wireless medium. The count includes data frames as well as control
and wireless management frames. The count does not include bad frames and
duplicate frames. For a description of these frames, refer to Bad frames
received and Duplicate frames discarded below.
Total received data frames: The total number of data frames received
the wireless medium, including duplicate frames. Refer to Duplicate f
discarded below.
Total Rx events: The total numbe
The following additional counters are displayed to indicate the reason f
failure:
Phy: The number of unidentified signals.
Overrun: The number of frames that were discarded because the recei
port.
Decrypt: The number of frames
problem in the data decryption mechanism.
Total received concatenated fr
are also separate counts for con
BreezeACCESS 4900 System Manual
80