User's Manual

Table Of Contents
Menus and Parameters
for
reg iguration.
reless: The number of frames transmitted to
es (excluding
ions, excluding Beacons in AU)
nsmitted to the wireless medium, excluding retransmissions.
This count is useful for calculating the rates of retransmissions or dropped
Total submitted frames (bridge): The total number of data frames submitted
re are also separate counts for each priority queue
through which the frames were routed (High, Mid and Low).
umber of dropped frames, which
are unsuccessfully retransmitted without being acknowledged until the
d
Total retransmitted frames: The total number of retransmissions, including
catenated
5.10
stations behind other BreezeACCESS 4900 units), is sent to the High queue,
ardless of the priority conf
The Wireless Link Counters include the following statistics:
Total transmitted frames to wi
the wireless medium. The total includes one count for each successfully
transmitted unicast frame (excluding retransmissions), and the number of
transmitted multicast and broadcast frames, including control and wireless
management frames. In the AU, there are also separate counters for the
following:
Beacons (AU only)
Management and Other Data frames, including successfully transmitted
unicast frames and multicast/broadcast data fram
retransmiss
Total Transmitted Unicasts (AU only): The number of unicast frames
successfully tra
frames, as only unicast frames are retransmitted if not acknowledged.
to the internal bridge for transmission to the wireless medium. The count
does not include control and wireless management frames, or
retransmissions. The
Frames dropped (too many retries): The n
maximum permitted number of retransmissions. This count includes droppe
data frames as well as dropped control and wireless management frames.
all unsuccessful transmissions and retransmissions.
Total transmitted concatenated frames: The total number of con
frames transmitted successfully to the wireless medium, excluding
retransmissions. There are also separate counts for concatenated frames that
include one frame (Single), two frames (Double) or more than two frames
(More). For more details refer to section 4.2.6.
.
smission Total Tx events: The total number of transmit events. Typically, tran
events include cases where transmission of a frame was delayed or was
Operation and Administration
79