User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
Menus and Parameters
Some or all of the security parameters may not be available in units that do not
support the applicable features. Refer to section 4.2.6.7
for a description of these
4.2.5 Site Survey Menu
The
ver
det
and
ide ential problems. In the AU, there is also an extensive database for
all SUs served by it.
The S ludes the following options:
Ping T
4.2.5.1 Traffic
The traffic statistics are used to monitor, interpret and analyze the performance
link
opt
Display Counters: Select this option to display the current value of the
Reset Counters: Select this option to reset the counters.
4.2.5.1.1 Et
The mes
to i frame should be
transmitted to the wireless medium. Frames discarded by the unit's hardware
parameters.
Site Survey menu displays the results of various tests and counters for
ifying the quality of the wireless link. These tests can be used to help
ermine where to position the units for optimal coverage, antenna alignment
troubleshooting. The counters can serve for evaluating performance and
ntifying pot
ite Survey menu inc
Traffic Statistics
est
Continuous Link Quality display (SU only)
MAC Address Database
Per Modulation Level Counters
Link Capability
Statistics
of the wired and wireless links. The counters display statistics relating to wireless
and Ethernet frames. The Traffic Statistics menu includes the following
ions:
Ethernet and wireless link (WLAN) counters.
hernet Counters
unit receives Ethernet frames from its Ethernet port and forwards the fra
ts internal bridge, which determines whether each
filter are not counted by the Ethernet counters. The maximum length of a regular
Operation and Administration
77