User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
Chapter 4 - Operation and Administration
Valid values: A string of up to 18 printable ASCII characters.
word option enables defining the password to be
rver that is hosting the file.
CII characters.
g File Upload Parameters: Displays the current values
of the Event Log Upload parameters.
The default is: vx
FTP Password: The FTP Pass
used for accessing the FTP se
Valid values: A string of up to 18 printable AS
The default is: vx
Show FTP Event Lo
NOTE
There is one set of gener P Server IP Address, FTP Gateway IP Address, al FTP parameters (FT
FTP Client IP Address, FTP Client IP Mask, FTP User Name and FTP Password). This set (or
relevant parts of the set) serves the SW Download procedure, the Configuration File
Upload/Download procedure and the Event Log File Upload procedure. Changing any of these
parameters in the menu for any procedure will automatically change its value in the menu for the
other procedures.
4.2.3.12 Feature Upgrade
ables to enter a license string for upgrading the
unit to support new features and/or options. Upon selecting the Manual Feature
be requested to enter the license string. Each license
string is associated with a unique MAC Address and one feature/option. If the
he unit’s MAC
ed. If there is a match, a message notifying of the
new feature/option will be displayed. The unit must be reset for the change to
The license string should comprise 32 to 64 hexadecimal digits.
New Feature License files can be uploaded remotely using TFTP (see
Appendix B
The Feature Upgrade option en
Upgrade option the user will
encrypted MAC Address in the license string does not match t
Address, the string will be reject
take effect.
).
4.2.4 guration Menu
udes all parameters required for the initial
installation and operation of the unit. After the unit is properly installed and
l parameters can be configured either locally or remotely
using Telnet or SNMP management.
Basic Confi
The Basic Configuration menu incl
operational, additiona
NOTE
All parameters in the Basic Configuration menu are also available in the relevant sub menus of the
Advanced Configuration menu.
The Basic Configuration menu enables to access the following parameter sets:
BreezeACCESS 4900 System Manual
74