User's Manual

Table Of Contents
Chapter 4 - Operation and Administration
The d gotiation (10/100 Mbps and Half/Full Duplex)
4.2.3.10
The Change System Location option enables changing the system location of the
un is also
displayed as a part of the Monitor menu’s header.
Valid values: A string of up to 35 printable ASCII characters.
4.2.3.11 Event Log Menu
ent Log Menu enables controlling the event log feature. The event log is an
from the configured severity and higher are saved and may be displayed upon
displayed up to the full number of current active
g Policy
4.2.3.11.1
minimal severity level. All events whose
everity is equal to or higher than the defined severity are logged.
.
Auto Negotiation (10/100 Mbps and Half/Full Duplex)
efault is Auto Ne
Change System Location
it, which is also the sys location in MIB2. The System Location
The default system location is an empty string.
The Ev
important debugging tool and a flash memory sector is dedicated for storing it.
Events are classified according to their severity level: Message (lowest severity),
Warning, Error or Fatal (highest severity).
The severity at which events are saved in the Event Log is configurable. Events
request. Log history can be
events. In the log, an event is defined as active as long as it has not been erased
(a maximum of 1000 events may be stored). The Event Log may be read using
TFTP, with remote file name <SNMP Read Community>.log (the default SNMP
Read Community is “public”). The Event Log may also be uploaded to a remote
FTP server.
The Event Log Menu includes the following options:
Event Lo
Display Event Log
Erase Event Log
Event Load Upload
Event Log Policy
The Event Log Policy determines the
s
Valid values are: Message (MSG) Level, Warning (WRN) Level, Error (ERR) Level,
Fatal (FTL) Level, Log None
The default selection is Warning Level severity.
BreezeACCESS 4900 System Manual
72