User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
About This Manual
This manual describes the BreezeACCESS 4900 Broadband Wireless Access
System Release 3.2 and how to install, operate and manage the system
components.
This manual is intended for technicians responsible for installing, setting up and
operating the BreezeACCESS 4900 system, and for system administrators
responsible for managing the system.
This manual contains the following chapters and appendices:
Chapter 1 – System description: Describes the BreezeAccess 4900 system and
its components.
Chapter 2 – Installation: Describes how to install the system components.
Chapter 3 – Commissioning: Describes how to configure basic parameters,
align the Subscriber Unit antenna and validate unit operation.
Chapter 4 – Operation and Administration: Describes how to use the
BreezeACCESS 4900 Monitor application for configuring parameters, checking
system status and monitoring performance.
Appendix A – Software Version Loading Using TFTP: Describes how to load a
new software version using TFTP.
Appendix B – File Download and Upload Using TFTP: Describes how to
download and upload configuration files using TFTP. This procedure is also
applicable for uploading country code and feature license files.
Appendix C – Using the Restore Link Parameters Utility: Describes how to use
the special Restore Link Parameters utility to enable management access to
units where wrong or unknown configuration disables regular access to the
unit for management purposes.
Appendix D – Preparing the indoor to outdoor cable: Provides details on
preparation of the indoor to outdoor Ethernet cable.