User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
Menus and Parameters
The default is: 0.0.0.0.
ng the password to be
e FTP server that is hosting the file.
Show Configuration File Upload/Download Parameters: Displays the
FTP User Name: The FTP User Name option enables defining the user name
to be used for accessing the FTP server that is hosting the file.
Valid values: A string of up to 18 printable ASCII characters.
The default is: vx
FTP Password: The FTP Password option enables defini
used for accessing th
Valid values: A string of up to 18 printable ASCII characters.
The default is: vx
current values of the Configuration File Upload/Download parameters.
NOTE
The Address, re is one set of general FTP parameters (FTP Server IP Address, FTP Gateway IP
FTP Client IP Address, FTP Client IP Mask, FTP User Name and FTP Password). This set (or
relevant parts of the set) serves the SW Download procedure, the Configuration File
Upload/Download procedure and the Event Log File Upload procedure. Changing any of these
para menu for any procedure will automatically change its value in the menu for the meters in the
other procedures.
4.2.3.8 Log
wh
The
The s.
4.2.3.9 Ethernet Port Negotiation Mode
The e current Ethernet port
state and enables defining the negotiation mode of the Ethernet port. The
ava
Force 10 Mbps and Full-Duplex
Force 100 Mbps and Half-Duplex
Out Timer
The Log Out Timer parameter determines the amount of inactive time following
ich the unit automatically exits the Monitor program.
time out duration can range from 1 to 999 minutes.
default value is 5 minute
Ethernet Port Negotiation Mode submenu displays th
ilable options are:
Force 10 Mbps and Half-Duplex
Force 100 Mbps and Full-Duplex
Operation and Administration
71