User's Manual

Chapter 4 - Operation and Administration
Table 4-4: Parameters that are not reset after Set Partial Factory/Operator Defaults
Parameters Group Parameter
Frequency (AU)
Frequency Subset (SU)
ATPC Option (AU)
Transmit Power
Tx Control (AU)
Best AU Support (SU)
Preferred AU MAC Address (SU)
Performance Parameters Adaptive Modulation Decision Thresholds
VLAN ID – Management Bridge Parameters
MAC Address Deny List (AU)
4.2.3.2.1.3 Se ults
Select this option to reset the unit to the Operator Defaults configuration,
4.2.3.2.1.4 Se
Select this option to reset the unit to the Operator Defaults configuration,
exc at are required to maintain connectivity and
management access. The parameters that do not change after Set Partial
4.2.3.2.1.5 Cancel Current Pending Request
Aft lts options, it will be executed after the next
reset. This option enables you to cancel the pending request before execution
4.2.3.2.2 Save Cur
The tion As Operator Defaults enables defining the
current configuration of the unit as the Operator Defaults configuration.
t Complete Operators Defa
excluding several parameters that are listed in Table 4-3.
t Partial Operator Defaults
luding the parameters th
Operator Defaults are listed in Table 4-4.
er selecting one of the Set defau
(provided the unit has not been reset yet).
rent Configuration As Operator Defaults
Save Current Configura
BreezeACCESS 4900 System Manual
66