User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
Menus and Parameters
4.2.2.3 Configuration
onfiguration menu enables to access the read only sub
menus that display the current values of the parameters included in the
s of the Advanced Configuration menu.
4.2.2.4
the parameters that are afftected by
zeACCESS 4900 supports two sets of frequencies
ese Sub-Bands, there is a set of parameters that
eral
rs include the following:
: Supported.
ion Support: Supported.
ndent Parameters:
Table 4-2: Sub-Band Dependent Parameters
Show Advanced
The Show Advanced C
applicable sub menu
Show Country Dependent Parameters
The Country Dependent Parameters displays
applicable regulations. Bree
(Sub-Bands). For each of th
reflects the applicable radio regulations. In addition, there are several gen
parameters that reflect availability of various security options. The Country
Dependent Paramete
Country Code: 1022 – FCC 4.9 GHz.
Data Encryption Support
AES Encrypt
Authentication Encryption Support: Supported.
Sub-Band Depe
Parameter Sub-Band 1 Sub-Band 2
Sub-Band ID 1 2
Frequenci
eps 5 MHz steps
es 4947.5 - 4982.5 MHz,
5 MHz st
4947.5 - 4982.5 MHz,
Allowed Bandwidth 10 MHz 5 MHz
Regula
Antenn
tion Max Tx Power at
a Port
20 dBm 17 dBm
Regula
SU: No Limit
: 43 dBm
SU: No Limit
tion Max EIRP AU: 46 dBm AU
Min Modulation Level 1 1
Max M 8 odulation Level 8
Burst M Enabled ode Enabled
Operation and Administration
61