User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
Chapter 4 - Operation and Administration
Show Advanced Configuration
Show Country Dependent Parameters
Show All Parameters
4.2.2.1 Show Unit Status
The Show Unit Status menu is a read only menu that displays the current values
of t
ed in the Unit Control menu.
es the unit's function: AU-BS (a modular access unit), AU-
SA (a stand-alone access unit), or SU-BD (a subscriber unit that supports a
Unit MAC Address: The unit's unique IEEE MAC address.
Current Number of Associations (AU only): The total number of SUs
mber may include units that are not
currently active as there is no aging algorithm for associated SUs.
he following parameters:
Unit Name: As defin
Unit Type: Identifi
gross CPE rate of 27 Mbps and a full LAN).
associated with this AU. This nu
NOTE
An SU is only removed from the list of associated SUs under the following conditions:
her AU indicating that the SU is now associated with the A SNAP frame is received from anot
other AU.
nsecutive frames transmitted by the AU and The SU failed to respond to a certain number of co
is considered to have "aged out".
Number of Associations Since Last Reset: For SUs - displays the total
s the number of SUs that
have associated with the AU since the last reset, including duplicate
me SU.
tus of the SU. There are two status
options:
SCANNING: The SU is searching for an AU with which to associate.
ed with an AU.
number of associations with any AU since the last reset, including duplicate
associations with the same AU. For AUs - display
associations with the sa
Unit Status (SU only): The current sta
ASSOCIATED: The SU is associat
BreezeACCESS 4900 System Manual
58