User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
Operation Verification
Table 3-4: SU-ODU LEDs
Name Description Functionality
W-LINK
Wireless Link
Green – Unit is associated with an AU,
Data received or
transmitted on the wireless link.
Blinking rate is proportional to wireless
te
Off – Wireless link is disabled
Indictor
no wireless link activity
Blinking Green –
traffic ra
Status Self-test power
er is available and
for
and
indication
Green – Pow
self-test passed.
Blinking Amber – Testing (not ready
operation)
Red – Self-test failed – fatal error
ETH Ethernet activity/
connectivity
indication
etween the
connectivity
ng
Green – Ethernet link b
indoor and outdoor units is detected,
no activity
Blinking Green – Ethernet
is OK, with traffic on the port. Blinki
rate proportional to traffic rate.
Red – No Ethernet connectivity
between the indoor and outdoor units.
SNR BAR
(SU-RA)
Received signal
strength Indication
w
e received
Red LED: Signal is too lo
(SNR<4 dB)
8 green LEDs: Quality of th
signal
Orange LED: Signal is too high
(SNR > 50 dB)
Commissioning
49