User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
Appendix H - Troubleshooting
H.1 Ethernet Port Connection Problems
Problem and Indication Possible Cause Corrective Action
Wrong type of Ethernet
cable
If connected directly to PC-use a
crossed cable. Otherwise-use a
straight cable
The Ethernet Integrity Indica
(the yellow LED embedded
tor
y
d
re
Faulty Ethernet cable R
in
the Ethernet connector) is off,
and/or the Ethernet Activit
Indicator (the green embedde
LED) does not blink when the
should be traffic on the
Ethernet port.
eplace cable
Wrong IP configuration Make sure that the PC is on the same
subnet as the unit*.
The unit does not respond to
ping.
et port Wrong Ethern
operation mode
Make sure that the speed and
settings in the PC match the
configuration in the unit (the default is
Auto Negotiation)
duplex
* If the IP parameters of the known, s utility to
restore the default factory c p eneral
FTP parameters and AU’s F P ad s of the unit after setting to factory
defaults is 10.0.0.1.
unit are un
onfiguration of all
requency). The I
use the Set Factory Default
arameters (except to Passwords, g
dres
BreezeACCESS 4900 System Manual
234