User's Manual
Table Of Contents
- BreezeACCESS 4900 System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation and Administration
- Working with the Monitor Program
- Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Advanced Configuration Menu
- IP Parameters
- Air Interface Parameters
- ESSID Parameters
- Frequency Definition Parameters
- Frequency Definition Submenu in AU
- Frequency Definition Submenu in SU
- Best AU Parameters (SU)
- Scanning Mode (SU only)
- Power Control Parameters
- Antenna Gain
- Cell Distance Parameters (AU only)
- Arbitration Inter-Frame Spacing (AIFS)
- Maximum Number of Associations (AU only)
- Wireless Link Trap Threshold (AU only)
- Spectrum Analysis
- Lost Beacons Transmission Watchdog Threshold
- Disassociate (AU only)
- Network Management Parameters
- Bridge Parameters
- VLAN Support
- Ethernet Broadcast Filtering (SU only)
- Ethernet Broadcast/Multicast Limiter
- Bridge Aging Time
- Broadcast Relaying (AU only)
- Unicast Relaying (AU only)
- MAC Address Deny List (AU only)
- Add MAC Address to Deny List
- Remove MAC Address from Deny List
- Roaming Option (SU only)
- Ports Control (SU only)
- Show Bridge Parameters
- Performance Parameters
- Service Parameters
- Security Parameters
- Appendix A - Software Version Loading Using TFTP
- Appendix B - File Download and Upload Using TFTP
- Appendix C - Using the Set Factory Defaults Utility
- Appendix D - Preparing the Indoor to Outdoor SU Cable
- Appendix E - Supported MIBS and Traps
- Appendix F - Parameters Summary
- Appendix G - Using the Feature License Web Application
- Appendix H - Troubleshooting
The Feature License Web Application
Using BreezeCONFIG: Enter the license string in the Feature Upgrade field of
the Unit Control window. Refer to the BreezeCONFIG User Manual
details.
for more
To upgrade multiple devices using a feature licenses file:
Using TFTP: Use the file with the extension “.fln” for feature licen
Refer to
Appendix B
se strings.
(File Upload and Download Using TFTP) for more details.
Note that Feature license files include multiple strings, where each string is
applicable only for a certain unit identified by its MAC address. When
uploading a e to multiple units, each unit
it.
Using BreezeCONFIG: Use the File Loading Utility. Refer to the
BreezeCONFIG User Manual for more details.
feature license or a country code fil
will accept only the parts that are applicable for
NOTE
After completing loading process, reset the unit(s) to apply the change. Use the Info Screens menu
(Show Unit Status) to verify that the unit has been upgraded.
BreezeACCESS 4900 System Manual
231